Intel SCH/TunnelCreek GPIO
modulename: gpio-sch.ko
and/orsch_gpio.ko
configname: CONFIG_GPIO_SCH
Linux Kernel Configuration
└─>Device Drivers
└─>GPIO Support
└─>Intel SCH/TunnelCreek GPIO
In linux kernel since version 2.6.34 (release Date: 2010-05-16)
Say yes here to support GPIO interface on Intel Poulsbo SCH
or Intel Tunnel Creek processor.
The Intel SCH contains a total of 14 GPIO pins. Ten GPIOs are
powered by the core power rail and are turned off during sleep
modes (S3 and higher). The remaining four GPIOs are powered by
the Intel SCH suspend power supply. These GPIOs remain
active during S3. The suspend powered GPIOs can be used to wake the
system from the Suspend-to-RAM state.
The Intel Tunnel Creek processor has 5 GPIOs powered by the
core power rail and 9 from suspend power supply.
This driver can also be built as a module. If so, the module
will be called sch-gpio.
or Intel Tunnel Creek processor.
The Intel SCH contains a total of 14 GPIO pins. Ten GPIOs are
powered by the core power rail and are turned off during sleep
modes (S3 and higher). The remaining four GPIOs are powered by
the Intel SCH suspend power supply. These GPIOs remain
active during S3. The suspend powered GPIOs can be used to wake the
system from the Suspend-to-RAM state.
The Intel Tunnel Creek processor has 5 GPIOs powered by the
core power rail and 9 from suspend power supply.
This driver can also be built as a module. If so, the module
will be called sch-gpio.