Philips ISP1301 with OMAP OTG
modulename: phy-isp1301-omap.ko
configname: CONFIG_ISP1301_OMAP
Linux Kernel Configuration
└─>Device Drivers
└─>USB support
└─>USB Physical Layer drivers
└─>I2C support
└─>Philips ISP1301 with OMAP OTG
In linux kernel since version 2.6.20 (release Date: 2007-02-04)
If you say yes here you get support for the Philips ISP1301
USB-On-The-Go transceiver working with the OMAP OTG controller.
The ISP1301 is a full speed USB transceiver which is used in
products including H2, H3, and H4 development boards for Texas
Instruments OMAP processors.
This driver can also be built as a module. If so, the module
will be called phy-isp1301-omap.
USB-On-The-Go transceiver working with the OMAP OTG controller.
The ISP1301 is a full speed USB transceiver which is used in
products including H2, H3, and H4 development boards for Texas
Instruments OMAP processors.
This driver can also be built as a module. If so, the module
will be called phy-isp1301-omap.
source code:
depends
CONFIG_ARCH_OMAP_OTGCONFIG_I2C
CONFIG_USB
CONFIG_USB_SUPPORT or CONFIG_ARCH_OMAP_OTG or CONFIG_ARM or CONFIG_COMPILE_TEST