POWER8 OCC through I2C
modulename: occ-p8-hwmon.ko
configname: CONFIG_SENSORS_OCC_P8_I2C
Linux Kernel Configuration
└─>Device Drivers
└─>Hardware Monitoring support
└─>POWER8 OCC through I2C
In linux kernel since version 5 (release Date: 2019-03-03)
This option enables support for monitoring sensors provided by the
On-Chip Controller (OCC) on a POWER8 processor. However, this driver
can only run on a baseboard management controller (BMC) connected to
the P8, not the POWER processor itself. Communications with the OCC are
established through I2C bus.
This driver can also be built as a module. If so, the module will be
called occ-p8-hwmon.
On-Chip Controller (OCC) on a POWER8 processor. However, this driver
can only run on a baseboard management controller (BMC) connected to
the P8, not the POWER processor itself. Communications with the OCC are
established through I2C bus.
This driver can also be built as a module. If so, the module will be
called occ-p8-hwmon.